Article ID : S500012859 / Last Modified : 11/04/2018

When I try to capture the digital video data using the IEEE1394 interface, I cannot sometimes capture it normally only to see an error message on the screen.

    When I try to capture the digital video data using the
    IEEE1394 interface, I cannot sometimes capture it normally
    only to see an error message on the screen.

    An error message is sometimes displayed, as some hard
    disk drives do not have adequate transfer speed.
    As some hard disk drive lacks in the transfer rate, an error
    message appears at the time of capturing digital video
    signals through the IEEE1394 interface and you sometimes
    fail to capture them normally.
    When it takes place, enable DMA if the hard disk drive
    supports it and you can sometimes avoid this symptom.

    For further details, refer to the following technical
    information of the support of Microsoft.