NEX Camera (E-mount)

IMPORTANT:

• When performing the firmware upgrade, please use a fully charged rechargeable battery pack NP-FW50 or the AC adaptor AC-PW20 (sold separately).
• Do not remove the battery or AC adaptor during the upgrade; otherwise, the camera may become inoperable due to the sudden power shutdown.
• Remove the memory card from the camera beforehand.

Start Firmware Updater

1. Double-click NEX-C3V2_Update1112a.exe to start up Firmware Updater.
   
    
   
   
2. Check the USB connection mode
   
   Select Menu → Setup → USB Connection on the camera, and confirm Mass Storage is selected. If the mode other than Mass Storage is selected, please select Mass Storage.
   
   
   
   
3. Connect the camera to the computer with the supplied USB cable.
   Note: When the camera is connected to the computer, the LCD screen of the camera turns off. Please proceed to the next step.
   
   
4. Confirm is displayed on the task tray at the lower right corner of the computer screen.
   
   
5. After confirming the above, click Next on Firmware Updater.
   Figure 4 appears on Firmware Updater and Figure 5 appears on the LCD screen of the camera.
   
   Figure 4: Firmware Updater
   
   
   
   Figure 5: Camera’s LCD screen
   
   
   
   Note: From this step onwards, never turn off the camera until the firmware upgrade is completed.
   
   
   
6. After confirming the screens on Figures 4 and 5, click Next. The current version and the version after the upgrade appear on the lower left part of the screen.
   
   Figure 6: Upgrade is required
   
   
   
   
   If the screen on Figure 7 appears, the upgrade is not required. According to the message, stop the USB connection and click Finish. Turn off the camera, remove the battery pack or the AC adaptor, and then turn on the camera again.
   
   Figure 7: Upgrade is not required
   
   
   
   
7. Click on the task tray at the lower right corner of the computer screen to stop the USB connection.
   
   Note: Please keep the USB cable connected even after stopping the USB connection on the computer with the above operation.
   
   
   
   
8. Press the center of the control wheel to reset the camera.
   
   Figure 9: Camera’s LCD screen
   
   
   
   Figure 10: Camera control wheel
   
   
   
   Note: The screen turns off when the center of the control wheel is pressed. Please proceed to the next step.
   
   
9. Click Next on Firmware Updater
   
   
   
   
10. After resetting, reconnection of the camera is verified, and the screen on Figure 11 appears.
    
    Figure 11
    
    
    
    
11. Click Run to start the upgrade. The progress bar appears while upgrading (approximately 5 minutes).
    
    Note: Never turn off the camera nor disconnect the USB cable while upgrading.
    
    
12. When the upgrade is completed, the screen on Figure 12 appears. Click Finish and disconnect the USB cable.
    
    Figure 12
    
    
    
    
13. Turn off the camera, remove the battery pack or the AC adaptor, and then turn on the camera again.
    
    

Check the firmware version

1. Select Menu → Setup → Version on the camera.
   
   
2. The firmware version is displayed. The firmware upgrade was completed successfully if Ver.02 is displayed.
   
    

The new functions provided by this firmware upgrade and their respective operations are described in below instruction manual links.

• English 
• Traditional Chinese 
• Simplified Chinese 
• Korean 
• Thai 
• Arabic 
• Persian